If this is the case, make sure the correct wiring is utilized and coordinate with the Carrier controls technician on the site.Please check your inbox, and if you cant find it, check your spam folder to make sure it didnt end up there.The display may also be retrofitted to competitors chillers when the 32 Series retrofit panels are applied.Tag all disconnect locations to alert others not to restore power until work is completed.
Carrier Comfortview Software Versions ListedThe EverVu display is supplied with databases to support the chiller software versions listed in Table 1. The EverVu display screens allow easy navigation to determine data and chiller trends such as a chiller performance trend, chilled water trend, condenser water trend and power trend. The EverVu touch screen display is available for Evergreen 19XR, 19XRV and 23XRV chillers and 32 Series chiller retrofit packages. The display is provided with ComfortVIEW software preloaded. ![]() If 120-v receptacle is not available, power may be obtained directly from the chiller power panel by following the instruction below. If the power cable of the display can be connected to a 120-v receptacle, this step is not necessary; proceed to Step 2. If the voltage is not within this range, STOP immediately and consult an appropriate electrical specialist. If not, STOP immediately and consult an appropriate electrical specialist. ![]() This serves to insulate the metal between the tube sheet and mounting bracket. Do not remove the plastic covering until you are ready to start up the touch screen. The display screen is shipped with the quick connect mount attached to the back of the screen. See Fig. 2. Hold the display screen until verifying that the display screen is supported by the hooks on the mounting bracket before releasing. See Fig. 4. To adjust tension on the up and down movement of the arm, tighten the hex screw on the top of the arm mount (Fig. Carrier Comfortview Serial Port OnThe converter should then be attached to the 9-pin serial port on the display. The software key will allow preloaded software to run automatically when the display screen is booted up. Pull the cord through the side of the back cover and attach to the display. Some older versions need to be updated to work with the touch panel. Contact a Carrier Service office for assistance in downloading a new version, if required.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |